Cisco XR 1200 series User Manual

path discover echo
To configure MPLS LSP echo parameters, use the path discover command in the appropriate configuration
mode. To use the default value, use the no form of this command.
path discover echo {interval time| maximum lsp selector ipv4 host address| multipath bitmap size size|
retry count| timeout value}
no path discover echo {interval time| maximum lsp selector ipv4 host address| multipath bitmap size
size| retry count| timeout value}
Syntax Description
Configures the interval (in milliseconds) between MPLS LSP echo requests
sent during path discovery. Range is 0 to 3600000. Default is 0.
interval time
Configures a local host IP address (127.x.x.x) that is the maximum selector
value to be used during path discovery. Default is 127.255.255.255.
maximum lsp selector ipv4
host-address
Configures the maximum number of selectors sent in the downstream mapping
of an MPLS LSP echo request during path discovery. Range is 1 to 256.
Default is 32.
multipath bitmap size size
Configures the number of timeout retry attempts for MPLS LSP echo requests
sent during path discovery. Range is 0 to 10. Default is 3.
retry count
Configures the timeout value (in seconds) for MPLS LSP echo requests sent
during path discovery. Range is 1 to 3600. Default is 5.
timeout value
Command Default
interval time: 0
maximum lsp selector ipv4 host address: 127.255.255.255
multipath bitmap size size : 32
retry count: 3
timeout value: 5
Command Modes
Path discover configuration
MPLS LSP ping configuration
Command History
ModificationRelease
This command was introduced.Release 3.6.0
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
184 OL-24735-01
IP Service Level Agreement Commands
path discover echo

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English