Cisco XR 1200 series User Manual

operation
To configure an IP SLA operation, use the operation command in IP SLA configuration mode. To remove
the operation, use the no form of this command.
operation operation-number
no operation operation-number
Syntax Description
Operation number. Range is 1 to 2048.
operation-number
Command Default
None
Command Modes
IP SLA configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the IP SLA operation command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)#
Related Commands
DescriptionCommand
Schedules an IP SLA operation.schedule operation, on page 215
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
174 OL-24735-01
IP Service Level Agreement Commands
operation

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English