Cisco XR 1200 series User Manual

key-chain
To configure the MD5 authentication for the IP SLA control message, use the key-chain command in IP SLA
configuration mode. To unset the keychain name and not use MD5 authentication, use the no form of this
command.
key-chain key-chain-name
no key-chain
Syntax Description
Name of the keychain.
key-chain-name
Command Default
No default values are defined. No authentication is used.
Command Modes
IP SLA configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
When you configure the key-chain command, you must also configure the key chain command in global
configuration mode to provide MD5 authentication.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the ipsla key-chain command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# key-chain ipsla-keys
Related Commands
DescriptionCommand
Creates or modifies a key chain.key chain
Configures an IP SLA operation.operation, on page 174
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
152 OL-24735-01
IP Service Level Agreement Commands
key-chain

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English