Cisco XR 1200 series User Manual

type icmp path-jitter
To use the ICMP path-jitter operation type, use the type icmp path-jitter command in IP SLA operation
configuration mode. To remove the operation, use the no form of this command.
type icmp path-jitter
no type icmp path-jitter
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
IP SLA operation configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the type icmp path-jitter command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type icmp path-jitter
RP/0/0/CPU0:router(config-ipsla-icmp-path-jitter)#
Related Commands
DescriptionCommand
Configures an IP SLA operation.operation, on page 174
Schedules an IP SLA operation.schedule operation, on page 215
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 285
IP Service Level Agreement Commands
type icmp path-jitter

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English