Cisco XR 1200 series User Manual

schedule period
To configure the amount of time during which all LSP operations are scheduled to start or run, use the schedule
period command in IP SLA MPLS LSP monitor schedule configuration mode. To remove the scheduler, use
the no form of this command.
schedule period seconds
no schedule period
Syntax Description
Amount of time in seconds for which label switched path (LSP) operations are
scheduled to run. Range is 1 to 604800.
seconds
Command Default
None
Command Modes
IP SLA MPLS LSP monitor schedule configuration
Command History
ModificationRelease
This command was introduced.Release 3.5.0
Usage Guidelines
Use the schedule period command to specify the amount of time in seconds during which all LSP operations
are scheduled to start running. All LSP operations are scheduled equally spaced throughout the schedule
period.
For example, if the schedule period is 600 seconds and there are 60 operations to be scheduled, they are
scheduled at 10-second intervals.
Use the frequency command to specify how often the entire set of operations is performed. The frequency
value must be greater than or equal to the schedule period.
You must configure the schedule period before you can start MPLS LSP monitoring. Start MPLS LSP
monitoring using the start-time command.
Task ID
OperationsTask ID
read, writemonitor
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 217
IP Service Level Agreement Commands
schedule period

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English