Cisco XR 1200 series User Manual

scan delete-factor
To specify the frequency with which the MPLS LSP monitor (MPLSLM) instance searches for provider edge
(PE) routers to delete, use the scan delete-factor command in the appropriate configuration mode. To return
to the default value, use the no form of this command.
scan delete-factor factor-value
no scan delete-factor
Syntax Description
Specifies a factor that is multiplied by the scan interval to determine the frequency at
which the MPLS LSP monitor instance deletes the provider edge (PE) routers that are
no longer valid. Range is 0 to 2147483647.
factor-value
Command Default
factor-value: 1
Command Modes
IP SLA MPLS LSP monitor ping configuration
IP SLA MPLS LSP monitor trace configuration
Command History
ModificationRelease
This command was introduced.Release 3.5.0
Usage Guidelines
The scan delete-factor command specifies a factor value for automatic PE deletion. The specified factor-value
is multiplied by the scan interval to acquire the frequency at which the MPLS LSP monitoring instance deletes
not-found PEs. A scan delete factor of zero (0) means that provider edge (PE) routers that are no longer valid
are never removed.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the scan delete-factor command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 1
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 209
IP Service Level Agreement Commands
scan delete-factor

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English