statistics
To set the statistics collection parameters for the operation, use the statistics command in the appropriate
configuration mode. To remove the statistics collection or use the default value, use the no form of this
command.
statistics {hourly| interval seconds}
no statistics {hourly| interval seconds}
Syntax Description
Sets the distribution for statistics configuration that is aggregated for over an
hour.
hourly
Collects statistics over a specified time interval. Interval (in seconds) over which
to collect statistics. Range is 1 to 3600 seconds.
interval seconds
Command Default
None
Command Modes
IP SLA operation UDP jitter configuration
IP SLA MPLS LSP ping configuration
IP SLA MPLS LSP trace configuration
IP SLA MPLS LSP monitor ping configuration
IP SLA MPLS LSP monitor trace configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
This command was added to IP SLA MPLS LSP monitor ping and
monitor trace configuration modes.
Release 3.5.0
Usage Guidelines
The statistics interval command is not supported for the configuration of ICMP path-echo and ICMP path-jitter
operations, nor for the configuration of MPLS LSP monitor instances.
If the statistics command is used in IP SLA operation mode, it configures the statistics collection for the
specific operation being configured. If the statistics command is used in IP SLA MPLS LSP monitor mode,
it configures the statistics collection for all operations associated with the monitored provider edge (PE)
routers. This configuration is inherited by all LSP operations that are created automatically.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
256 OL-24735-01
IP Service Level Agreement Commands
statistics
To Next Page
Loading...
Need help?
General
