Cisco XR 1200 series User Manual

mpls lsp-monitor
To configure MPLS label switched path (LSP) monitoring, use the mpls lsp-monitor command in IP SLA
configuration mode. To use the default value, use the no form of this command.
mpls lsp-monitor
no mpls lsp-monitor
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
IP SLA configuration
Command History
ModificationRelease
This command was introduced.Release 3.5.0
Usage Guidelines
Use the mpls lsp-monitor command to configure MPLS LSP PE monitoring on the router. This provides a
means to configure all operations associated with the monitored provider edge (PE) routers. The configuration
is inherited by all LSP operations that are created automatically by the PE discovery.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to enter IP SLA MPLS LSP monitor mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)#
Related Commands
DescriptionCommand
Configures an IP SLA MPLS LSP monitor instance.monitor, on page 168
Configures MPLS label switched path (LSP) provider
edge (PE) router discovery.
mpls discovery vpn, on page 170
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
172 OL-24735-01
IP Service Level Agreement Commands
mpls lsp-monitor

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English