Cisco XR 1200 series User Manual

monitor mode, it acts on the MPLS echo requests for all operations associated with the monitored provider
edge (PE) routers.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the lsp selector ipv4 command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type mpls lsp trace
RP/0/0/CPU0:router(config-ipsla-mpls-lsp-trace)# lsp selector ipv4 127.10.10.1
Related Commands
DescriptionCommand
Configures an IP SLA operation.operation, on page 174
Schedules an IP SLA operation.schedule operation, on page 215
Tests connectivity in an LSP path in an MPLS VPN.type mpls lsp ping, on page 286
Traces the hop-by-hop route of an LSP path in an
MPLS VPN.
type mpls lsp trace, on page 288
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 161
IP Service Level Agreement Commands
lsp selector ipv4

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English