Cisco XR 1200 series - Page 272

Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the tag command in IP SLA UDP jitter configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# tag ipsla
The following example shows how to use the tag command in IP SLA MPLS LSP monitor ping configuration
mode:
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 1
RP/0/0/CPU0:router(config-ipsla-mplslm-def)# type mpls lsp ping
RP/0/0/CPU0:router(config-ipsla-mplslm-lsp-ping)# tag mplslm-tag
Related Commands
DescriptionCommand
Configures an IP SLA operation.operation, on page 174
Schedules an IP SLA operation.schedule operation, on page 215
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
260 OL-24735-01
IP Service Level Agreement Commands
tag (IP SLA)