Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the ttl command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type mpls lsp ping
RP/0/0/CPU0:router(config-ipsla-mpls-lsp-ping)# ttl 200
Related Commands
DescriptionCommand
Configures an IP SLA operation.operation, on page 174
Schedules an IP SLA operation.schedule operation, on page 215
Tests connectivity in an LSP path in an MPLS VPN.type mpls lsp ping, on page 286
Traces the hop-by-hop route of an LSP path in an
MPLS VPN.
type mpls lsp trace, on page 288
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
282 OL-24735-01
IP Service Level Agreement Commands
ttl
To Next Page
Loading...
