Cisco XR 1200 series User Manual

monitored provider edge (PE) routers. This configuration is inherited by all LSP operations that are created
automatically.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the type mpls lsp ping command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type mpls lsp ping
RP/0/0/CPU0:router(config-ipsla-mpls-lsp-ping)#
The following example shows how to use the type mpls lsp ping command in IP SLA MPLS LSP monitor
configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 2
RP/0/0/CPU0:router(config-ipsla-mplslm-def)# type mpls lsp ping
RP/0/0/CPU0:router(config-ipsla-mplslm-lsp-ping)#
Related Commands
DescriptionCommand
Configures an IP SLA MPLS LSP monitor instance.monitor, on page 168
Configures MPLS label switched path (LSP)
monitoring.
mpls lsp-monitor, on page 172
Configures an IP SLA operation.operation, on page 174
Schedules an IP SLA MPLS LSP monitoring instance.schedule monitor, on page 213
Schedules an IP SLA operation.schedule operation, on page 215
Traces the hop-by-hop route of an LSP path in an
MPLS VPN.
type mpls lsp trace, on page 288
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 287
IP Service Level Agreement Commands
type mpls lsp ping

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English