Cisco XR 1200 series

Task ID
OperationsTask ID
read, write, executemonitor
Examples
This example shows how to enable the BGP protocol monitoring using the criterion set in the default template:
RP/0/0/CPU0:router(config)#performance-mgmt apply monitor bgp 10.0.0.0 default
This example shows how to enable monitoring for data rates according to the criterion set in the default
template:
RP/0/0/CPU0:router(config)#performance-mgmt apply monitor interface data-rates pos 0/2/0/0
default
This example shows how to enable memory monitoring based on the criterion set in the default template:
RP/0/0/CPU0:router(config)#performance-mgmt apply monitor node memory location 0/1/cpu0
default
Related Commands
DescriptionCommand
Applies a statistics template and enables statistics
collection.
performance-mgmt apply statistics, on page 374
Creates a template to use for collecting performance
management statistics.
performance-mgmt statistics, on page 386
Displays a list of templates and the template being
applied.
show running performance-mgmt, on page 411
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 373
Performance Management Commands
performance-mgmt apply monitor