Citrix SD-WAN Series - Page 207

Citrix SD-WAN Platforms
• Method 1: Import virtual machine
1. In the navigation pane, under Hyper-V Manager, select the server on which you want to
install SD-WAN VPX.
2. On the Actions menu, click Import Virtual Machine.
3. In the Import Virtual Machine dialog box, in Location box, specify the path to the folder
that contains the SD-WAN VPX files.
Note
If you received a compressed file, make sure that you extract the files into a folder
before you specify the path to the folder.
4. Click Import.
5. Verify that the virtual appliance that you created is listed under Virtual Machines.
6. Right-click the virtual machine, and then click Settings.
7. In the Settings window’s navigation pane, under Hardware, select the first network
adapter in the list.
8. In the Network drop-down menu, select apA1 Network. This is the LAN interface for apA1.
9. Make sure the Enable MAC address spoofing box is selected. If it is not, select it and apply
the changes.
10. In the Settings window’s navigation pane, under Hardware, select the second network
adapter in the list. Repeat the step 10 and step 11, and assign the adapter to apA2 Network.
This is the WAN interface for apA2. Important: Do not configure the same Network for both
the network adapters. Incorrect configuration creates packet loops, which can bring down
the network.
11. Optionally, change the virtual hard disk size:
– In the Settings window navigation pane, under IDE Controller 0, select Hard Drive.
– Click Edit.
– Follow the steps in the Edit Virtual Hard Disk Wizard to increase the allocation to one
of the supported sizes, using the Expand option in the wizard.
12. Optionally, change the memory size.
– In the Settings window’s navigation pane, under Hardware, select Memory.
– Allocate the RAM space by adjusting the memory to one of the supported sizes.
– Click OK.
13. Optionally, define the management port.
– Right-click the virtual machine, and then click Settings.
© 1999-2021 Citrix Systems, Inc. All rights reserved. 207