Citrix SD-WAN Platforms
tions.
Deploying a Citrix SD-WAN VPX instance on an SDX appliance includes the following tasks:
• Installing the hardware: ensure the SDX hardware is properly installed. For more information,
see Installing the Hardware.
• Setting up and configuring the SDX Management Service. For more information, see Getting
Started with the Management Service User Interface and Configuring the Management Service.
• Provisioning the SD-WAN VPX instance on the SDX appliance. For more information, see Provi-
sion the Citrix SD-WAN VPX instance on a Citrix ADC SDX.
• Configuring the SD-WAN VPX instance. For more information, see the Configuration documen-
tations and Configuring the virtual path service between the MCN and client sites.
Prerequisites
Ensure you’ve the following licenses:
• Citrix SD-WAN VPX license
• Citrix ADC SDX platform license
Citrix SD-WAN VPX requirements
The Citrix SD-WAN VPX on SDX platform can act both as a site and MCN. The MCN can handle 1 Gb/s
bidirectional throughput and 64 sites.
Supported throughput for MCN and site
• 250 Mb/s to 1 Gb/s bidirectional throughput
• MCN supports 64 sites
Hardware requirement for supported throughput
Site
• 4 CPUs to 16 CPUs
• 4 GB to 16 GB RAM
• 60 GB to 250 GB disk storage
• Minimum 4 NICs: one for management and remaining minimum 3 for data path
Master control node (MCN)
• 4,8, and 16 CPUs
• 16 GB RAM
• 250 GB disk storage
© 1999-2021 Citrix Systems, Inc. All rights reserved. 378
To Next Page
Loading...
Need help?
General