Citrix SD-WAN Platforms
5. On the PC, open a browser and enter the default IP address for the appliance. Enter the follow-
ing IP address in the address line of the browser: 192.168.100.1
Note: Use Google Chrome browser when connecting to an SD-WAN appliance. Ignore any
browser certificate warnings for the Management Web Interface.
The SD-WAN management web interface login screen on the connected appliance is displayed.
1. Enter the administrator user name and password, and click Login. Aer you log into the man-
agement web interface, the Dashboard page appears.
• Default administrator user name: admin
• Default administrator password: password
Note
Change the default password. Record the password in a secure location, as password recovery
might require a configuration reset.
Install Fiber Patch Cable in Ports 10/3 and 10/4
Through release 9.3, on an appliance, SD-WAN ports 10/3 and 10/4 must be connected with the pro-
vided cable, as shown in the following figure.
Note
Fiber patch cable for 10/3 and 10/4 port is applicable only to the 4000 and 5000 WANOP series
appliances.
Starting with release 9.3, the patch cable is no longer required, and can be omitted if:
• The appliance was shipped from the factory with release 9.3 or later, or
• The appliance was shipped from the factory with release 9.3 or earlier, but you upgrade it to
later version and change the default loopback in the management service (on System > Con-
figuration > System > Configure Loopback Settings).
If you decide to eliminate the need to use loopback cable, the ports 10/3 and 10/4 are still reserved.
These ports are not available for WAN optimization.
To install the patch cable
1. Connect the LC-to-LC cable to the ports as shown in the figures above.
2. Insert one end of the cable into port 10/3.
3. Insert the other end of the cable into port 10/4.
© 1999-2021 Citrix Systems, Inc. All rights reserved. 53
To Next Page
Loading...