SRM Console Diagnostics 4-3
Table 4–1 Summary of Diagnostic and Related Commands
(Continued)
Command Function
kill
Terminates a specified process.
kill_diags
Terminates all executing diagnostics.
more el Same as cat el, but displays the console event log one
screen at a time.
memexer
Runs a requested number of memory tests in the
background.
memtest
Tests a specified section of memory.
net -ic
Initializes the MOP counters for the specified Ethernet
port.
net -s
Displays the MOP counters for the specified Ethernet
port.
nettest
Runs loopback tests for PCI-based Ethernet ports. Also
used to test a port on a “live” network.
set sys_serial_
num
Sets the system serial number, which is then propagated
to all FRUs that have EEPROMs.
show error
Reports errors logged in the FRU EEPROMs.
show fru
Displays information about field replaceable units (FRUs),
including CPUs, memory DIMMs, and PCI cards.
show_status Displays the progress of diagnostic tests. Reports one line
of information for each executing diagnostic.
sys_exer
Exercises the devices displayed with the show config
command
sys_exer -lb
Runs console loopback tests for the COM2 serial port and
the parallel port during the sys_exer test sequence.
test
Verifies the configuration of the devices in the system.
test -lb
Runs loopback tests for the COM2 serial port and the
parallel port in addition to verifying the configuration of
devices.
To Next Page
Loading...
Need help?
General
