System Configuration and Setup 6-23
6.4.3 Setting the Level of Memory Testing
Set the level of memory testing that occurs when the system is power
cycled from the advanced CMOS Setup screen.
Figure 6–6 Advanced CMOS Setup Screen
PK0903a
Advanced CMOS Setup F1=Help
Press or to enable or disable power-up memory testing.
When enabling memory test, PARTIAL will test the first 256 MB,
FULL will test all of the memory.
ESC=Discard Changes F10=Save Changes
PCI Parity Checking: Disabled
Power-up Memory Test: Partial
AlphaBIOS Password Option: Disabled
SCSI BIOS Emulation: Enabled For All
Console Selection: Windows NT Console (AlphaBIOS)
1.
From Advanced CMOS Setup, select Power-up Memory Test.
2.
Select the level of memory testing you want to occur when the system is
power cycled. The three memory test settings are:
Disabled No memory test performed by AlphaBIOS
Partial Tests first 256 MB of memory
Full Tests all of the memory
To Next Page
Loading...
Need help?
General
