Compaq AlphaServer ES40 User Manual

7-24 Compaq AlphaServer ES40 Service Guide
7.6.6 Configuring Remote Dial-In
Before you can dial in through the RMC modem port or enable the
system to call out in response to system alerts, you must configure RMC
for remote dial-in.
Connect your modem to the 9-pin modem port and turn it on. Connect to the
RMC CLI from either the local serial terminal or the local VGA monitor to set
up the parameters.
Example 7–8 Dial-In Configuration
RMC> set password ➊
RMC Password: ****
Verification: ****
RMC> set init
➋
Init String: AT&F0E0V0X0S0=2
RMC> enable remote
➌
RMC> status ➍
.
.
Remote Access: Enabled
.
.
.
NOTE: The following modems require the initialization strings shown here.
For other modems, see your modem documentation.
Modem Initialization String
Motorola 3400 Lifestyle 28.8 AT&F0E0V0X0S0=2
AT &T Dataport 14.4/FAX AT&F0E0V0X0S0=2
Hayes Smartmodem Optima 288
V-34/V.FC + FAX
AT&FE0V0X0S0=2

Compaq AlphaServer ES40 Specifications

General

Brand	Compaq
Model	AlphaServer ES40
Category	Server
Language	English