System Configuration and Setup 6-39
Startup password protection provides more comprehensive protection than
setup password protection because with startup protection the system cannot be
used at all until the correct password is entered.
To enable password protection:
1.
Start AlphaBIOS Setup, select CMOS Setup, and press Enter.
2.
In the CMOS Setup screen, press F6 to enter Advanced CMOS Setup.
3.
In the Advanced CMOS Setup screen (Example 6–5), select AlphaBIOS
Password Option and use the arrow keys to select the type of protection
you want. An explanatory dialog box appears. Read the dialog box and press
Enter to continue.
4.
Enter your password in the Enter New Password dialog box, then press
Enter.
5.
Enter your password in the Confirm New Password dialog box, then press
Enter.
6.
Press F10 to save your changes.
NOTE: To change your password, set up your password again.
To Next Page
Loading...
Need help?
General
