Using the Remote Management Console 7-11
Connecting from the Local VGA Monitor
To connect to the RMC CLI from the local VGA monitor, the console
environment variable must be set to graphics and the SRM console must be
running.
Invoke the SRM console and enter the rmc command.
P00>>> rmc
You are about to connect to the Remote Management Console.
Use the RMC reset command or press the front panel reset
button to disconnect and to reload the SRM console.
Do you really want to continue? [y/(n)] y
Please enter the escape sequence to connect to the Remote
Management Console.
After you enter the escape sequence, the system connects to the CLI and the
RMC> prompt is displayed.
When the RMC CLI session is completed, reset the system with the Reset
button on the operator control panel or issue the RMC reset command.
RMC> reset
Returning to COM port
To Next Page
Loading...
Need help?
General
