Using the Remote Management Console 7-21
➊
DPR address
➋
Number of bytes dumped (in hex). In the example the dump command
dumps EF bytes from address 10.
➌
Bytes 10:15 are the time stamp. See Appendix C for the meaning of other
locations.
The dump command allows you to dump data from the DPR. You can use this
command locally or remotely if you are not able to access the SRM console
because of a system crash.
The dump command accepts two arguments:
Address:
Prompts for the starting address
Count:
Prompts for the number of following consecutive bytes. If no
count is specified, the count defaults to 0.
To Next Page
Loading...
