FRU Removal and Replacement 8-9
Before Replacing Non Hot-Plug FRUs
Follow the procedure below before replacing any non hot-plug FRU.
1.
Shut down the operating system.
2.
Shut down power to external options, where appropriate.
3.
Turn off power to the system.
4.
Unplug the power cord from each power supply.
WARNING: To prevent injury, unplug the power
cord from each power supply before installing
components.
After Replacing FRUs
After you have replaced FRUs and have determined that the system has been
restored to its normal operating condition, you must clear the system error
information repository (error information logged to the DPR).
Use the clear_error all command to clear all errors and initialize the central
error repository. See Chapter 4 for details.
To Next Page
Loading...
