FRU Removal and Replacement 8-27
Replacing a CPU Card
1.
Remove the covers from the fan area and the system card cage.
2.
Pull up on the clips at each end of the card and remove the card.
3.
Install the new CPU card in the connector and push down firmly on both
clips simultaneously.
NOTE: When installing an additional CPU, remove the blank CPU air
deflector from the next available slot.
Verification — SRM Console
1.
Turn on power to the system.
2.
During power-up, observe the screen display. The newly installed CPU
should appear in the display.
3.
Issue the show config command. The new CPU should be listed as one of
the processors.
Verification — AlphaBIOS
1.
Start AlphaBIOS Setup, select Display System Configuration, and press
Enter.
2.
Using the arrow keys, select Systemboard Configuration and check the
Processor field to determine how many processors the system sees.
To Next Page
Loading...
Need help?
General
