Contax I4R - Tips for Erasing Images Using [PROTECT] and [ERASE ALL]

Introduction Getting Ready Taking Pictures Playback Set Up
EN-106
BACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
 Tips for Erasing Images Using [PROTECT] and [ERASE ALL]
For example, if you have 100 recorded images and you only want to keep 5 or 6 of them, using [ERASE] or
[SELECT AND ERASE] to erase individual images can be very time-consuming.
In a situation like this, where you have a large number of recorded images and you only want to keep a few
of them, you can accomplish it in just a few steps using [PROTECT] and [ERASE ALL].
1 First protect the images you want to keep. ( "[U] Protecting Images from
Accidental Erasing (PROTECT)" Æ p.104)
2 Then erase all the images. ( "Erasing all the images (ERASE ALL)" Æ p.103)
All the unprotected images are erased, leaving just the protected images behind.