Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-46
NEXT
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Shooting Movies
«Applicable mode: M»
You can use the camera to shoot movies with sound.
1 Turn the camera on and press the mode
button until "M" lights up on the mode
select LED.
The movie mark and remaining shooting time appear at the top of the
screen.
2 Compose the shot.
3 Press the shutter release button down
half way to set the focus.
The camera gives a short double-beep, the green shooting mark "Z"
lights on the LCD monitor and the focus frame turns green to indicate
that the focus has been set.
BNote
• During movie shooting, the exposure is adjusted according to the ambient
conditions, but the focus does not change. The entire movie is shot using the focus
set just before shooting started.
• The shooting mark "Z" flashes when the focus is not set. Press the shutter release
button half way again until the shooting mark "Z " stays lit and the focus is set.
• When the focus frame (Æ p.70
) is set to [MULTI AF], the selected focus frame
turns green.
00:26
Pipip
00:26
To Next Page
Loading...
Need help?
General
