Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-27
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Charging the Battery
1
Place the camera in the USB cradle.
2 Plug the AC adapter AC-73L into the USB
cradle to charge.
Charge time is approximately 3 hours.
Turn the camera off during charging.
The caution LED (red) turns on when the camera is charging, and turns
off after approximately 2 hours at which point the battery pack is 90%
charged.
Leaving the AC adapter connected for approximately one hour more
charges the battery pack fully.
A Important
Ensure that the battery pack is inserted in the camera before charging.
BNote
Refer to "Using the USB Cradle" (Æ p.36) for
details on attaching the USB cradle.
A Important
• When you first purchase the camera, you need to charge the battery fully.
• If the battery pack is repeatedly charged with the battery pack or camera containing the
battery left in a hot location, the battery pack will deteriorate, reducing the number of
photos that can be taken. When this occurs, replace the battery pack with a new one.
• Remove the camera from the USB cradle and turn the power on to check the camera
battery level. (Æ p.33
)
BNote
The AC adapter supports voltages of up to 240 V. When you are charging the camera in a
foreign country, use the AC adapter cable that matches the voltage and power socket of
that country. You do not need to use a voltage transformer or other devices.
To Next Page
Loading...
Need help?
General
