Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-186
NEXT
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Troubleshooting
Check the items listed below before deciding that your camera is faulty.
Problems and Solutions
Problem Cause Solution Page
Nothing appears
on the LCD
monitor.
The batteries are flat, or the
Lithium Ion battery pack is
not inserted.
Insert the Lithium Ion battery
pack into the camera and
recharge the camera.
25
27
The Power Save function
has turned the camera off.
Turn the camera on again.
31
The LCD
monitor is blank.
If you leave the camera for a
while without using it, the
camera goes into Sleep
mode.
Press the shutter release button
half way or press any other
camera button to restore the
camera to Shooting mode. The
details vary depending on the
Power Save function settings.
165
There is something
generating a magnetic field
(such as a magnet or TV)
close to the camera.
Move the camera further away
from the magnetic object.
-
A video cable is connected
to the USB cradle the
camera is placed in.
Disconnect the video cable from
the USB cradle. 149
There's no
image on the TV.
You are using the wrong
video output format.
Use the correct video output
format for the TV.
178
The number of
available shots
did not change
when I took a
picture.
This is because the
photographed image size
was small.
This is dependent on factors
such as the number of pixels
and the subject and is not a
problem.
-
I cannot erase
an image. "U"
icon displayed.
The image is protected. Unprotect the image.
104
To Next Page
Loading...
Need help?
General
