Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-39
NEXT
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Taking Still Images
«Applicable mode: C»
You can use this camera in various ways. You can take still images, shoot a
sequence of consecutive shots (continuous shooting), and shoot movies.
This chapter begins by explaining how to shoot photos (still images).
1 Turn the camera on and press the mode
button until "C" lights up on the mode
select LED.
The startup screen appears and then the date is displayed for
approximately 3 seconds.
Check that the date is correct.
2 Compose the shot by looking at the LCD
monitor.
BNote
Press the 4-way button right to zoom in on the
image, and left to zoom back out. (Æ p.59
)
Avoiding camera shake
Camera shake refers to the effect of images appearing blurred or out of focus because the camera moved
when the picture was taken. This is particularly likely to occur at slow shutter speeds and in macro shots.
This applies particularly to macro shots with high magnifications, where the subject's depth of field
is
extremely shallow, and even the slight camera movement when the shutter release button is pressed can
have a large impact on the image.
In situations of this sort, place the camera on a stable surface to take the shot. Even greater stability can be
achieved by using the self-timer (Æ p.57
) so that the camera does not move when the shutter release
button is pressed.
To Next Page
Loading...
Need help?
General
