Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-173
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
To set a user-defined screen (MULTI)
1 Turn the camera on and press the mode
button until "G" lights up on the mode
select LED.
The SET UP menu screen is displayed.
2 Press the 4-way button up or down to
select [START SCREEN], then press right.
3 Press the 4-way button up or down to
select [MULTI], then press the OK button
E.
4 Press the 4-way button left or right to
select the center location, then press
down.
The image selection screen appears showing the still images stored on
the memory card.
A Important
Check that the memory card containing the images you want to use is inserted into the
camera.
BNote
If you select [RESET], the reset confirmation
message appears. Select [EXECUTE] and press
the OK button E to delete the user-defined screen
set previously from the camera's memory.
BEEP
SHUTTER VOL
START SCREEN
REC REVIEW
+2
+2
SET
2SEC
ENGLISH
VIDEO OUT NTSC
SET UP(2/3)
LANGUAGE
MULTI
SINGLE
OFF
SELECT START SCREEN
RESET
SELECT START SCREEN
SELECT IMAGE
OK
To Next Page
Loading...
Need help?
General
