Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-179
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
[STARTUP MODE] Setting the Mode the Camera Starts In
The camera can be set to always start in still image mode when turned on,
or to start in the same mode as the last time it was turned off.
1 Turn the camera on and press the mode
button until "G" lights up on the mode
select LED.
2 Press the 4-way button up or down to
select [STARTUP MODE], then press right.
3 Press the 4-way button up or down to
select the desired mode, then press the
OK button E.
The selected setting is applied.
[STILL] : The camera switches to still image mode when it is turned on.
(Default)
[LOCK] : When you turn the camera on, the camera uses the mode
used last time the power was turned off.
BNote
This setting is retained when you turn the camera off.
STARTUP MODE
DISPLAY INFO
FILE NO.
MODE RESET
STILL
ON
EXECUTE
EXECUTE
SET UP(3/3)
STARTUP MODESTARTUP MODE
DISPLAY INFODISPLAY INFO
FILE NO.FILE NO.
MODE RESETMODE RESET
STILL
LOCKLOCK
EXECUTEEXECUTE
EXECUTEEXECUTE
SET UP(3/3)
To Next Page
Loading...
Need help?
General
