Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-137
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Viewing images on a Windows PC
1 Insert the memory card into the camera.
(Æ p.28
)
2 Place the camera in the USB cradle and
connect the AC adapter.
3 Use the USB cable supplied with the camera to connect the
USB cradle holding the camera to the PC, then start the PC.
A Important
• If you are using Windows 98 or Windows 98SE, install the USB drivers before
connecting the USB cable. (Æ p.135
)
• If you are using Windows Me, Windows 2000 or Windows XP, you do not need to install
the USB drivers. Connect the USB cable without installing the drivers.
• To view images on your PC, you must have image-viewing software already installed.
(To play movies, QuickTime 4.1 or later is required.)
• Always use the AC adapter when you connect the camera to a computer to view and
copy images, etc. If the battery runs out and the camera turns off, files may be
corrupted.
A Important
You cannot view images on the PC unless there is
a memory card in the camera.
BNote
Refer to "Using the USB Cradle" (Æ p.36) for
details on attaching the USB cradle.
A Important
Check the sizes of the USB connectors. Plug the small connector into the USB cradle
and the large connector into the USB port on your PC.
To Next Page
Loading...
Need help?
General
