Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-170
NEXT
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
[START SCREEN] Selecting the Startup Screen
Use this procedure to select one of the following as the startup screen that
is displayed when you turn the camera on:
• CONTAX logo (SINGLE) : The CONTAX logo screen is displayed for approximately 1 second.
(Default)
• CONTAX logo (MULTI) : The CONTAX logo animation is displayed for approximately 1 second.
• User-defined screen (SINGLE) : You can choose an image from those saved on the memory card to display
for approximately 1 second.
• User-defined screen (MULTI) : You can choose multiple images from the memory card to display
sequentially for approximately 1 second to form an animation. (up to 10
images)
• OFF screen : No startup screen is displayed.
To set the CONTAX logo screen (SINGLE/MULTI)
1 Turn the camera on and press the mode
button until "G" lights up on the mode
select LED.
The SET UP menu screen is displayed.
2 Press the 4-way button up or down to
select [START SCREEN], then press right.
BNote
When you turn the power on, the camera runs a check on the memory card. If there is a lot
of data stored on the memory card, the startup screen is displayed until the check
operation is finished. If the camera is configured for a multi startup screen, the final frame
is displayed for an extended period after the animation has finished until the check
operation is finished.
BEEP
SHUTTER VOL
START SCREEN
REC REVIEW
+2
+2
SET
2SEC
ENGLISH
VIDEO OUT NTSC
SET UP(2/3)
LANGUAGE
To Next Page
Loading...
Need help?
General
