Contax I4R User Manual

Introduction Getting Ready Taking Pictures Playback Set Up
EN-178
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
[VIDEO OUT] Setting the Output Format for a TV Connection
You can choose between NTSC and PAL video output formats when the
camera is connected to a television through the VIDEO OUT port on the
USB cradle. Different TV signal formats are used in different countries.
When you are on holiday, you should configure the video output to match
the format for your destination country.
1 Turn the camera on and press the mode
button until "G" lights up on the mode
select LED.
2 Press the 4-way button up or down to
select [VIDEO OUT], then press right.
3 Press the 4-way button up or down to
select the video output format, then press
the OK button E.
The selected setting is applied.
[NTSC]: Video output format used in, for instance, Japan and the U.S..
(Default)
[PAL] : Video output format used mostly in Europe.
BNote
If the D connector cable is connected, the camera will automatically switch to D3 output
format regardless of this setting.
BNote
This setting is retained when you turn the camera off.
BEEP
SHUTTER VOL
START SCREEN
REC REVIEW
+
2
+
2
SET
2SEC
ENGLISH
VIDEO OUT NTSC
SET UP(2/3)
LANGUAGE
BEEP
SHUTTER VOL
START SCREEN
REC REVIEW
+
2
+
2
SET
2SEC
VIDEO OUT
NTSC
PAL
SET UP(2/3)
LANGUAGE

Contax I4R Specifications

General

Brand	Contax
Model	I4R
Category	Digital Camera
Language	English