Contax I4R - Setting the Flash Mode

Introduction Getting Ready Taking Pictures Playback Set Up
EN-61
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Setting the Flash Mode
1 Turn the camera on and press the mode
button until "C" lights up on the mode
select LED.
2 Press the 4-way button up to select the
icon for the mode you want to set.
The flash mode icon changes in the cycle shown below each time you
press the 4-way button up.
BNote
This setting reverts to the default value when you turn the camera off.
(Default)