Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-142
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Deleting the Device (Windows 98 and Windows 98SE only)
If the driver software is not installed successfully, the PC will be unable to
recognize the camera.
If this occurs, use the procedure below to delete the device. Then use the
procedure on p.135
to re-install the drivers.
* Note that this operation is only required for Windows 98 and Windows
98SE.
1 Insert the memory card into the camera.
(Æ p.28
)
2 Place the camera in the USB cradle and
connect the AC adapter.
3 Use the USB cable supplied with the camera to connect the
USB cradle holding the camera to the PC, then start the PC.
BNote
Refer to "Using the USB Cradle" (Æ p.36) for
details on attaching the USB cradle.
A Important
Check the sizes of the USB connectors. Plug the small connector into the USB cradle
and the large connector into the USB port on your PC.
To Next Page
Loading...
Need help?
General
