Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-26
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Removing the Battery Pack
1
Check that the camera is switched off
and then release the card/battery cover
latch.
qUse the pad of your finger to slide the card/battery cover in the
direction of the arrow until there is a click and the latch is released
(approximately 1 mm).
wThe bottom part of the card/battery cover opens (approximately
10 mm).
2 Open the card/battery cover.
ePull out the card/battery cover until it is stopped by the hinge.
rFully open the card/battery cover.
3 Rotate the battery stopper to unlock the
battery pack.
When you turn the catch in the direction of the arrow, the battery pack
pops out a small distance.
4 Grasp the battery pack and pull it out of
the camera.
A Important
• Take care that you do not drop the battery pack.
The strong impact of dropping the battery pack
may cause it to heat up or leak battery fluid.
• Depending on the operating conditions of the
camera, the battery pack may heat up. Be
careful when removing the battery pack from the
camera.
BNote
If you do not intend to use the battery pack for a
long period of time, store it in a cool environment.
2
1
4
3
Hinge
Battery Stopper
To Next Page
Loading...
Need help?
General
