Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-47
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
4 Press the shutter release button down
fully.
The camera starts shooting the movie.
During movie shooting, the shooting mark (a red "Z") appears and the
self-timer LED lights. The elapsed shooting time is displayed in the
upper right of the screen and the focus frame disappears.
When the remaining shooting time drops below approx. 10 seconds, the
time display turns red.
The table below shows the available shooting times for each image size using a 256 MB memory card.
(Times given are for a new or freshly formatted high speed memory card at a frame rate of 30fps)
Available shooting time display in movie mode
• The shooting time shown on the LCD monitor when you start shooting in movie mode does not indicate
the time available for one continuous shot. The length of a continuous movie shot is limited by the speed
at which data is written to the SD memory card and differs depending on the card you are using.
• If you use a high-speed SD memory card (an SD memory card with a write speed of 10 MB/sec or
faster), the available shooting time displayed on the LCD monitor serves as a guide to the actual
continuous shooting time available.
5 Press the shutter release button half way to stop shooting.
Image Size Time
640 x 480 Approx. 1 min.
50 sec.
320 x 240 Approx. 7 min.
A Important
Depending on the SD memory card write speed, the camera may stop shooting mid-
shot.
BNote
If you do not press the shutter release button half way, shooting continues until the
memory card is full.
00:1800:18
To Next Page
Loading...
Need help?
General
