Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-167
BACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Notes on using the power save function (in "C" or "M" mode)
Depending on the power save setting, the camera operates as follows:
• When [POWER SAVE] is set to [15SEC], [30SEC], [1MIN.] or [3MIN.].
If the camera is left turned on for the configured time or longer, the LCD monitor automatically goes blank
for two minutes (sleep mode).
While the camera is in sleep mode, it can be quickly returned to its original shooting mode by pressing the
shutter release button half way or by pressing any of the other function buttons.
However, the camera turns off after the two minutes have passed.
• When [POWER SAVE] is set to [NO PWR OFF].
If the camera is left turned on for six minutes or more, the LCD monitor goes blank.
In this case, the LCD monitor remains blank but the camera is not turned off. To return the camera to its
normal shooting mode, press the shutter release button half way or press any of the other function
buttons.
: Shooting mode
: Sleep mode (LCD monitor blank). Pressing the shutter release button half way or pressing
any of the other function buttons returns the camera to shooting mode.
: Camera turned off
1MIN.
(Default)
3MIN.
NO PWR OFF
2 minutes1 minute
3 minutes 2 minutes
6 minutes
30SEC
2 minutes
30 seconds
15SEC
2 minutes
15 seconds
To Next Page
Loading...
Need help?
General
