Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-188
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
The picture
came out
completely
white.
The image is overexposed. Set the exposure compensation
to a negative value, or execute
mode reset.
64
183
There is a lot of
'noise' in the
image.
Noise is more likely to occur
if high ISO settings are used.
Use the flash or reduce the ISO
sensitivity before shooting. 66
I can't rotate
images, protect
images, specify
DPOF
settings
or format the
memory card.
The SD memory card is
write-protected.
Remove the write-protection for
the card.
29
When I connect
the camera to
my computer, no
[Removable
disk], [untitled]
or [NO_NAME]
icon appears.
The USB cable is not
connected properly.
Make sure that the USB cable is
securely connected.
137
145
The USB cable is connected
to the keyboard or to the
USB port on a USB hub.
Plug the USB cable into the USB
port on the PC. -
The drivers are not installed,
or installation failed.
Follow the procedure described
in Deleting the Device (Windows
98 and Windows 98SE only).
142
I cannot connect
to the printer.
The printer does not support
PictBridge
.
Refer to the instructions
provided with the printer.
-
The printer is not connected
correctly.
Check that the camera is
correctly connected to the
printer with the USB cable.
125
Movies cannot be printed. - -
You cannot use DPOF
printing if the printer does not
support DPOF printing.
Refer to the instructions
provided with the printer. -
Problem Cause Solution Page
To Next Page
Loading...
Need help?
General
