Introduction Getting Ready
Taking Pictures
Playback Set Up
EN-44
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
3 Compose the shot.
4 Press the shutter release button down
half way to set the focus.
5 Press the shutter release button down
fully.
The camera shoots pictures continuously for as long as you hold the
button down.
A Important
• This setting is retained when you turn the camera off.
• To ensure that you obtain approximately 3.0 frames per second (approx. 1.4 frames per
second for AF continuous shooting) performance, you should format (Æ p.161
) the SD
memory card in the camera beforehand. If you repeatedly shoot and erase frames, the
continuous shooting speed may drop. If this occurs, save the images to your PC and
then format the memory card using the camera before continuing.
• The number of continuous shots that can be taken varies depending on the type and
capacity of the memory card in the camera and on the subject. Continuous shooting
stops when the memory card is full of recorded images.
• The speed at which data is written to a memory card varies according to the type of card
used.
• If you use an SD memory card that is intended for high-speed recording, you can use
continuous shooting to shoot at approximately 3.0 frames per second (approx. 1.4
frames per second for AF continuous shooting) until the memory card is full. (The speed
varies depending on the subject.)
• If slower shutter speeds are used because the subject is dark, the continuous shooting
speed may be slower than 3.0 frames per second (or approx. 1.4 frames per second for
AF continuous shooting).
• If you use the flash, the camera cannot shoot continuously.
• When you erase a single image from the middle of a group of continuous images, the
group splits into 2 groups of continuous images.
Pipip
To Next Page
Loading...
Need help?
General
