117
4. 4WD shaft disassembling.
1) Remove 4WD shaft and gear
5. PTO shaft removal
1) Remove fixing bolts of bearing cap and
remove bearing cap from transmission case.
2) Remove PTO shaft and gears.
6-4 CLUTCH HOUSING REASSEMBLING
*Assemble the clutch housing with reverse
procedure of disassembling.
(1) COVER B REINSTALLATION
Reinstall the cover B with reverse procedure
of removal.
Use following adjustment and service
standards for the reassembling.
(2) COVER B REASSEMBLING
*Reassemble the cover B with reverse
procedure of disassembling.
Use following adjustment and service
standards for the reassembling.
1. Counter shaft end play adjustment
Adjust the end play at counter shaft to
[0.002in.~0.008in.] by liner.
2. Drive shaft end play adjustment
Adjust the end play at drive shaft to
[0.002in.~0.008in. ] by liner.
To Next Page
Loading...
