119
2) Install the sleeve to hub that the bigger
chamfer side of sleeve face to spline step
side of hub.
3) Install the spring with shifting the setting
position of spring between both sides of hub.
(2) COVER C REASSEMBLING
*Reassemble the cover C with reverse
procedure of disassembling. Use following
values as adjustment and service standard for
reassembling.
1. Drive Shaft
1) Adjust the end play at drive shaft to
[0.002~0.079in.] by liner.
2. Select Shaft
1) Adjust the end play at select shaft to
[0.002~0.079in.] by liner.
To Next Page
Loading...
