Cub Cadet 7360SS

133
(3) KNUCKLE ARM, FINAL CASE
DISASSEMBLING
(4) KING PIN CASE DISASSEMBLING
1. Remove fixing bolts of knuckle arm and
remove knuckle arm from gear case.
2. Remove fixing bolts of cover and remove
cover from gear case.
3. Remove snap ring (1) and remove bearing (2),
gear 38T, liner and axle shaft from cover.
4. Remove snap ring (3) and bearing (4) from
cover.
(1)KING PIN CASE
(2)KING PIN SHAFT
(3)LINER
(4)GEAR 18T
(5)GEAR CASE L.H.
(6)GEAR 14T
(7)LINER
(8)CENTER CASE L.H.
(9)DIFFERENTIAL SHAFT
(10)GEAR 13T
(11)ARM HOLDER
(12)COVER
(13)BEARING
(14)BEARING