146
9-4. OPERATOR CONTROL AREA
REASSEMBLING
*Reassemble operator control area with
reverse procedure of disassembling.
(1) STEERING WHEEL REINSTALLATION
*Reinstall steering wheel with reverse
procedure of removal. Use following values as
adjustment and service standard.
4) Check the tilt amount at steering wheel
which is approximate [0.827 in.] and side
play which should be less than [0.079 in.].
2. Tightening torques [36.17lbf•ft]
Hoses [18.08lbf•ft]
1. Adjustment of tilt lever
1) Tighten the bolts (17) until locking the
steering column..
2) Loosen the bolts (17) of L.H. side and R.H.
side equally until tilt force at steering wheel
comes to [21.7~108.5 lbf•ft ] and lock them
by lock nut (19).
3) Check the tilt force at steering wheel after
lock the lock nut (19).
(1)STEERING UNIT
(2)COLUMN
(3)PLATE
(4)BOLT
(5)NUT
(6)BOOT
(7)SHAFT
(8)STEERING WHEEL
(9)CENTER PAD
(10)NUT
(11)HOSE L (RED TAPE)
(12)HOSE R
(13)TILT LEVER
(14)BOLT
(15)NUT
(16)SPRING
(17)BOLT
(18)DISK SPRING
(19)NUT
(20)LINER
(21)BOLT
To Next Page
Loading...
Need help?
General