19
2-2 ENGINE REINSTALLATION
*Install the engine with reversed procedure of
removal
Use following adjustment and service standards
for the reinstallation.
1. When reinstall the engine to clutch housing,
apply the liquid packing (Threebond #1208D)
to the mating surface of engine rear plate and
clutch housing.
2. When installing the engine, make sure that
main shaft and clutch center is aligned
3. Tightening torque of engine mounting bolts
61.5~68.7 lbf.ft (8.5~9.5 kgf-m)
4. Tightening torque of chassis mounting bolts
68.7~83.2 lbf.ft (9.5~11.5 kgf-m)
5. Tightening torque of power steering hose at
transmission side.
36.2~43.4 lbf.ft (5~6 kgf-m)
To Next Page
Loading...
