Cub Cadet 7360SS

15
2. ENGINE ASSY REMOVAL AND REINSTALLATION
2-1 ENGINE ASSY REMOVAL
(1) HARNESSES REMOVAL
1. Remove front grille, bonnet, side covers and
panel cover.
2. Disconnect battery cable (Disconnect
negative cable first and then disconnect
positive cable.)
3. Disconnect the harnesses at alternator and
starter motor. Disconnect the tachometer
cable.
4. Disconnect the harnesses at water
temperature gauge, water temperature
sensor and glow plug.
5. Disconnect the harnesses at oil pressure
sensor, fuel cut solenoid, electric fuel feed
pump and fuel gauge.
6. Disconnect the engine control wires (2 wires)
at governor side. Disconnect the engine
control wire for foot accel pedal from step.
Remove the power steering hoses (2 hoses)
from steering cylinder.