50
(2)Put the rear plate in position on the
cylinder block with its dowel holes in
alignment with the dowels. Tighten the
bolts that hold the rear plate to the
specified torque.
Tightening torque
Install the starter to the rear plate before
installing the plate to the cylinder block for
convenience of rear plate installation.
11.Tappet installation
Lubricate the tappets with engine oil and put
them in position in the cylinder block.
12.Oil seal case installation
(1)Put new gasket in position on the oil seal
case.
(2)Lubricate the oil seal lip with engine oil
and install the oil seal in position in the
cylinder block.
13.Rear plate installation
(1)Put a new gasket in position on the rear
plate.
6.5 1 kgf•m
(47 7 lbf•ft)
[64 10 N•m]
14.Flywheel installation
(1)Install a safety bar(M12x1.25)in the
rear end of the crankshaft.
(2)Put the flywheel in position in alignment
with the safety bar.
(3)Install three of four bolts in the flywheel
and tighten them finger tight only.
(4)Remove the safety bar. Install the last bolt
in the flywheel and tighten it finger tight only.
To Next Page
Loading...
