34
4-3. DISASSEMBLING
(1)CYLINDER HEAD DISASSEMBLY
1.Rocker cover
2.Rocker shaft assembly
3.Push rod
4.Cylinder head bolt
5.Cylinder head
6.Cylinder head gasket
7.Valve lock
8.Valve retainer
9.Valve spring
10.Valve
11.Stem seal
12.Valve cap
1.Rocker shaft assembly removal
(1)Remove the bolts that hold the rocker
stays in position and remove the rocker
shaft assembly.
(2)Remove the valve caps.
2.Rocker shaft disassembly
Put identification on each rocker arm as to its
location on the rocker shaft.
3.Cylinder head bolt removal
Loosen the cylinder head bolts in two or three
steps in the sequence shown.
If any parts on the cylinder head are faulty,
check the cylinder head bolts for tightness
with a torque wrench before loosening them.
Cylinder head bolt loosening sequence.
To Next Page
Loading...
