Cub Cadet 7360SS - Housing Reinstallation; Hydraulic Lift Case Reinstallation; Rear Axle Case Reinstallation

23
3) Remove mounting bolts of ROPS lower
bracket and remove the bracket.
2. Disconnect the brake rod at brake lever on
the rear axle case.
3. Lift the rear axle case and remove the
mounting bolts.
4. Remove the rear axle assy.
3-2. HOUSING REINSTALLATION
*Reinstall the housings with reverse procedure
of the removal. Use following values as
adjustment and service standard for the
installation.
(1) Rear axle case reinstallation
1. Apply the liquid packing (Threebond
#1280D) to the mating surface of the rear
axle case and transmission case.
2. Tightening torque of rear axle case
mounting bolts.
61.5~68.7lbf.ft (8.5 ~ 9.5 kgf-m)
(2) Hydraulic lift case reinstallation
1. Apply the liquid packing (Threebond
#1280D) to the mating surface of the
hydraulic lift case and transmission case.
2. Tighten the top link bracket mounting bolts
before tightening the hydraulic lift case fixing
bolts.
3. Tightening torque of hydraulic case fixing
bolts.
61.5~68.7 lbf.ft (8.5 ~ 9.5 kgf-m)
4. Tightening torque of the top link bracket
mounting bolts.
86.8~97.6 lbf.ft (12 ~ 13.5 kgf-m)